Gold Member Since 2009
Audited Supplier
SanShine Electronics (Xiamen) Technology Co., Ltd.

DC Biase Current Source, DC Magnetization Current Source, Lcr Meter manufacturer / supplier in China, offering DC Biase Current Source (SS1010), Programable AC Withstand Voltage and Insulation Resistance Tester (SS7112), Lcr Tester Transformer Automatic Tester (SS3250) and so on.

(/ )

DC Biase Current Source (SS1010)

This product is currently unavailable, but you may contact the supplier directly, for further interest.
Basic Info
  • Model NO.: SS1010
  • Installation: Direct Connected
  • Kind: Rotating Coil
  • Theory: Electronic Meter
  • Display Ammeter Type: Single-phase Digital
  • DC Bias Current Source: for Inductance Measurement of Inductors and Trans
  • Frequency Response Range: 500Hz ~ 300kHz
  • Output Voltage Range: 0 ~ 8V
  • Origin: China
  • Display: Digital
  • Accuracy: 1%
  • Power Source: AC Meter
  • Application: Electronic Equipment
  • Customized: Non-Customized
  • Current Range: -10A ~ 10A (DC)
  • Current Accuracy: ±1% of Reading±3 Counts
  • Trademark: SanShine
Product Description
SS1010, a DC Bias Current Source (or DC Magnetization Current Source), is mainly used for inductance measurement of inductors and transformer windings with DC bias current. Except for constant current output, low additional error and wide frequency response range are important for bias current inductance measurement. High frequency LCR meter could be used, when the frequency response range is wide enough. MPU controlled automatic current balance technology is adopted to realize AC+DC current overlap and constant current output from 0 to ± 10A. With its low additional error, wide frequency response range and sweep output function, the meter is widely used in DC biased inductance measurement. It also provides a perfect solution for magnetic material analysis.
1.20× 2 large-character LCD display with backlight
2. Frequency response range: 500 Hz - 300 kHz
3.0- 10A current output, full-load power 90 W
4. Low additional error and wide frequency response range
5. Current's automatic or manual scanning output
6. Three current output modes: Single-point sweep, multi-point sweep, and part sweep
7. Large current output for long time
8.0_99s delay time setup
9. DC current output with forward or reverse
10. Optional GPIB and RS232 interfaces
11. User's data automatically stored
12. Anti-shock protection to prevent LCR meter from being damaged
Current range
-10A ~ 10A (DC)
Current resolution
200mA range: 0.1mA
2A range: 0.001A
10A range: 0.01A
Frequency response range
500HZ ~ 300KHZ
Impedance range
Current accuracy
±1% of reading±3 counts
Output voltage range
0 ~ 8V
Additional error
≤ 1%
Current output mode
Sigle, multi and Equal interal current output
Sweep mode
Manual,Auto(Return sweep available)
Sweep points
2 ~ 15points
Delay time
0 ~ 99s setup
Warm-up time
20 minutes
Working time
continuous work up to 24 hours
Operating temperature and humidity
0 ~ 40 ºC, ≤ 90%RH
Power consumption
≤ 200VA
390 X 150 X 410mm
Send your message to this supplier
Mr. Toney
To: Mr. Toney

Enter between 20 to 4,000 characters.

This is not what you are looking for? Post a Sourcing Request Now

Find Similar Products By Category